Syringe Heater Kit

Heater control unit & 120Vac 33W,2 thermocouple,54cm cord,9cm x7.5cm 

Model: HEATER-KIT-1LG

Heater Kit is shown for demonstration purposes. Syringe pump and syringe are not included with Heater Kit.

Syringe Heater Kit,HEATER-KIT-1LG

Description:

Thermo-Kinetic Heat Clamp for syringes that require temperature-controlled dispensing. Heats up to 185°C.

Specification Notes:

• Available in 2 versions:

• 1LG Heating Pad: 3.5" x 3.0" LxW (9 cm x 7.5 cm)

• 5SP Heating Pad: 20" x 0.625" LxW (50 cm x 1.5 cm)

• Heater Kit includes control unit and primary syringe heater pad 1LG version or 5SP version.

• Multiple syringe heater pads can be attached to the control unit, under restricted conditions.

• Set point and other parameters retained in memory

• Digitally sets the heater set point

• Controller will heat the syringe and hold the set temperature using an on/off or Thermo-kinetic control algorithm.

• Dual temperature sensors in primary heating pad.

• Alarm modes with multiple layers of protection to prevent temperature overrun.

• Additonal heat protection for the pump may be needed when heating syringes above 100°C.

• If you are in a country where the voltage is above 120V, you must purchase a step-down transformer (Model: PWR-220-110-E) along with the Heater Kit.

Syringe Heater Kit

Heater control unit & 120Vac 33W,2 thermocouple,54cm cord,9cm x7.5cm 

Model: HEATER-KIT-1LG

Heater Kit is shown for demonstration purposes. Syringe pump and syringe are not included with Heater Kit.

Description:

Thermo-Kinetic Heat Clamp for syringes that require temperature-controlled dispensing. Heats up to 185°C.

Syringe Heater Kit

Heater control unit & 120Vac 33W,2 thermocouple,54cm cord,9cm x7.5cm 

Model: HEATER-KIT-1LG

Heater Kit is shown for demonstration purposes. Syringe pump and syringe are not included with Heater Kit.

Description:

Thermo-Kinetic Heat Clamp for syringes that require temperature-controlled dispensing. Heats up to 185°C.

Specification Notes:

• Available in 2 versions:

• 1LG Heating Pad: 3.5" x 3.0" LxW (9 cm x 7.5 cm)

• 5SP Heating Pad: 20" x 0.625" LxW (50 cm x 1.5 cm)

• Heater Kit includes control unit and primary syringe heater pad 1LG version or 5SP      version.

• Multiple syringe heater pads can be attached to the control unit, under restricted      conditions.

• Set point and other parameters retained in memory

• Digitally sets the heater set point

• Controller will heat the syringe and hold the set temperature using an on/off or      Thermo-kinetic control algorithm.

• Dual temperature sensors in primary heating pad.

• Alarm modes with multiple layers of protection to prevent temperature overrun.

• Additonal heat protection for the pump may be needed when heating syringes above 100°C.

• If you are in a country where the voltage is above 120V, you must purchase a step-down      transformer (Model: PWR-220-110-E) along with the Heater Kit.

Syringe Heater Kit,HEATER-KIT-1LG